Troubleshooting 8-21Fail to access the hard disk drive:(Refer to the documentation supplied with the RAID Controller.)T Is the hard disk drive applicable to the server?→ Operation of any device that is not authorized by NEC is not guaranteed.T Is the hard disk drive properly installed?→ See Chapter 9.Fail to access the (internal or external) SCSI devices:T Is the SCSI device applicable to the server?→ Operation of any SCSI device that is not authorized by NEC is not guaranteed.T Is the cable connection changed?→ See Chapter 10 for cable connection.T Are SCSI devices properly configured?→ When the server has external SCSI devices connected, hard disk drive settings,including SCSI ID and terminator, are required. Refer to the manual that comeswith the SCSI device for details.T Is cable length exceeded?→ Refer to the manual that comes with the SCSI device for details.T Are the optional SCSI controllers properly configured?→ Use the BIOS Setup utility for proper configuration of SCSI devices connected tothe SCSI connector on the mother board. When the server has an optional SCSIcontroller installed and SCSI devices connected to it, use the BIOS Setup utilitythat comes with the optional SCSI controller for proper configuration. See themanual that comes with the optional SCSI controller for details.
