9-46 Upgrading Your ServerIDE Device1. Provide the proper setting for the device.See the table below for the settings of the devices which can be installed in the device bay.Device SettingIDE device Termination resistance: OFF2. See the section "Preparing for Installation and Removal" described earlier to prepare.3. Remove the left side cover and the front mask as described earlier in this chapter.4. Remove all the cables from the factory-installed optical disk drive and the devicesinstalled in the device bay.5. Remove the factory-installed optical disk drive with the release tabs on the both sides ofthe drive pushed.6. Secure the device to be installed to the rail with two screws provided with the device.
