9-18 Upgrading Your Server3.5-inch Disk ModelYou can build a RAID System by using the Onboard RAID Controller (LSI Embedded MegaRAID)or optional RAID Controller (N8103-90/116/117).Onboard RAID Controller (LSI Embedded MegaRAID)RAID Controller is factory embedded in your mother board. Setting RAID configuration jumperswitch allows internal hard disk drives to be recognized as RAID drives. Set the LSI EmbeddedMegaRAID jumper switch as shown in the figure below.NOTE: By the shipping default, RAID System is set to "Enabled".Run the BIOS SETUP utility. Select [Advanced] → [Peripheral Configuration] → [SATA ControllerMode Option] → [Enabled]. Then select [Advanced] → [Peripheral Configuration] → [SATARAID] → [Enabled]. At the factory, [SATA Controller Mode Option] is set to [Enhanced], and[SATA RAID] is set to [Enabled]. See Chapter 4 for details.Use LSI Software RAID Configuration Utility to configure the RAID System. See Chapter 4 fordetails.Disables RAIDconfigurationEnables RAIDconfiguration
