Troubleshooting 8-27Problems with NEC EXPRESSBUILDERWhen the server is not booted from the NEC EXPRESSBUILDER DVD, check the following:T Did you set the NEC EXPRESSBUILDER during POST and restart the server?→ If you do not set the NEC EXPRESSBUILDER during POST and restart theserver, an error message will appear or the OS will boot.T Is BIOS configuration correct?→ The boot device order may be specified with the BIOS SETUP utility of the server.Use the BIOS Setup utility to change the boot device order to boot the systemfrom the optical disk drive first.If [OS installation ***default***] is selected at BOOT Selection screen, following message isdisplayed.After this message appears, check the error and take the appropriate corrective action according tothe message listed in the table below.Message CauseThis EXPRESSBUILDER version was not designedfor this computer.Insert the correct version and click [OK]. (When youclick [OK], the computer reboots.)This NEC EXPRESSBUILDER version isnot designed for this server.Execute the NEC EXPRESSBUILDER onthe compliant server.EXPRESSBUILDER could not get the hardwareparameters written in this motherboard.This version is not designed for this computer or themotherboard may be broken. (When you click [OK],the computer reboots.)The hardware parameters written in thismotherboard are incorrect.This version is not designed for this computer or themotherboard may be broken.This message is shown when NECEXPRESSBUILDER could not find system-specific information because of motherboard exchange and so on.
