Voyager Reference Guide 141IPoA ExampleThis section describes how you might configure the interfaces of yournetwork application platform (Nokia Platform) in an example network, usingVoyager.Before you can configure interfaces using Voyager, you must first configurean IP address on one of the interfaces. You can do this through the NokiaPlatform console port during installation or by using the Lynx browser. Thisallows a graphical browser such as Internet Explorer or Netscape Navigator toaccess the Nokia Platform through that interface. You can use any graphicalweb browser to configure the other interfaces on the unit by entering the IPaddress of the unit in the location field of the browser.The figure below shows the network configuration for this example.A company has five ethernet networks in three separate locations. Thenetworks are connected to each other using three routers that belong to thesame logical IP subnet over ATM. We are configuring the ATM interface onATMSwitch00125eth-s1p1c0eth-s1p1c0 eth-s2p2c0 eth-s1p1c0 eth-s2p2c0atm-s2p1c0 (10.0.0.1/24)PVC 42 to Nokia Platform BPVC 53 to Nokia Platform Catm-s3p1c0 (10.0.0.3/24)atm-s3p1c0 (10.0.0.2/24)Nokia Platform ANokia Platform CNokia Platform B
