7 Configuring Traffic Management382 Voyager Reference Guide5. To change the cluster IP address for an interface, enter a new IP address inthe C LUSTER IP A DDRESS field for that interface, then click APPLY andSAVE.6. To change the hash, click the drop-down arrow in the Hash Selectioncolumn and select one of the options, then click APPLY and SAVE.Deleting a Cluster ConfigurationIf you want to delete all the cluster configuration information and remove anode from a cluster, you must log into the node as admin. On the ClusteringSetup Configuration page, click DELETE.Synchronizing the Time on Cluster NodesYou probably want to keep the times on the cluster nodes synchronized. If yourun Check Point’s VPN-1/FireWall-1, be sure to do so to prevent problemswith firewall synchronization.To make sure that the time is synchronized on cluster nodes you must:! assign the same time zone to each node! configure NTP so that each node gets its time from the same time serverAssigning the Time ZoneTo conveniently assign the same time zone to each node, follow these steps:1. Log into Cluster Voyager2. Under System Configuration, click Local Time Setup3. Select the appropriate time zone.4. Click A PPLY.All the cluster nodes are now set to the time zone you specified.
