5 Configuring Interfaces192 Voyager Reference GuideFrame Relay ProtocolChanging the Keepalive Interval in Frame Relay1. Click C ONFIG on the home page.2. Click the Interfaces link.3. Click the physical interface link you want to configure in the PHYSICALcolumn.Example—ser-s2p14. Enter a number in the K EEPALIVE edit box to configure the Frame Relaykeepalive interval. Click APPLY.This value sets the interval, in seconds, between keepalive protocolmessage transmissions. These messages are used periodically to test foran active remote system.NoteThis value must be identical to the keepalive value configured on thesystem at the other end of a point-to-point link, or the link state fluctuates.To make your changes permanent, click SAVE.Changing the DLCI in Frame RelayTo move an IP address from one PVC to another, you must first delete thelogical interface for the old PVC, then create a new logical interface for thenew PVC.1. Click C ONFIG on the home page.2. Click the Interfaces link.
