7 Configuring Traffic Management358 Voyager Reference GuideThis step does not apply if you are using VPN-1/FireWall-1 NG withApplication Intelligence or later. It is sufficient to configure IP pools inFireWall-1.8. Deselect any features that should not be cluster sharable.9. Change the cluster state to UP .10. Save the cluster configuration to disk.11. If you disabled firewall monitoring in step 4, reenable it.12. Create cluster configurations on the other nodes.13. Join the other nodes to the cluster.The failure interval and performance rating are set by default on each nodeand generally should not be changed. See “Configuring the Failure Interval”and “Configuring the Performance Rating” for more information about thesefeatures.You must also configure the VPN-1/FireWall-1 to work with the IPSO cluster.Use the Check Point client application to add a gateway object for the Nokiaappliance. You also must create a gateway cluster object and add the gatewayobject to it. Refer to the Check Point documentation and “Configuring VPN-1/FireWall-1 for Clustering” for details.Creating a Cluster1. Click C ONFIG on the home page.2. Click Clustering Setup in the Traffic Management section. The ClusteringSetup Configuration page appears.3. Enter a cluster ID (0-65535).4. Enter a password for the user cadmin.You must use the same password on each node that you add to the cluster.This is also the password that you use to log into Cluster Voyager.5. Enter the password for cadmin again (for verification).6. Click A PPLY.
