Voyager Reference Guide 497! Ability to telnet to port 25! Support for mail accounts other than admin or monitorConfiguring Mail RelayIn Voyager, follow these instructions to configure mail relay for your firewall.1. Click CONFIG on the home page.2. Click the Mail Relay link in the System Configuration section.3. Enter either the IP address or hostname of the mail server that relaysoutgoing e-mail in the M AIL SERVER edit box.4. Enter the username on the mail server to which mail addressed to adminor monitor is sent in the REMOTE USER edit box; then click A PPLY.To make your changes permanent, click SAVE.Sending MailThis procedure describes how to send mail from the firewall.1. Log into the firewall using either your admin or monitor account.2. At the prompt, type the mail command, followed by a space, and theusername of the recipient:mail username@hostname3. Type the subject of your message at the subject prompt; then press enter.4. Type your message; then press enter.5. When you finish typing your message, type a period on an empty line;then press enter.Your message will be sent.
