CS193/CS173/CS163 12-25Utility mode 12Expert AdjustmentParameter Description Default SettingAE Level Adjustment Specify the initial value for auto exposure (AE) be-tween 0 and 4. The higher the setting, the morethat the original background is emphasized.Standard (2)Printer Ad-justmentLeading EdgeAdjustmentAdjust the starting print position between -3.0 and3.0 mm at the leading edge of the paper (with re-spect to the paper feed direction). Adjustmentscan be specified for each paper type.0.0 mmCentering Adjust the starting print position between -3.0 and3.0 mm at the left edge of the paper (with respectto the paper feed direction). Adjustments can bespecified for each paper tray.0.0 mmLeading Edge Ad-justment (DuplexSide 2)Adjust the starting print position between -3.0 and3.0 mm at the leading edge of the paper for thesecond side during automatic double-sided cop-ying. Adjustments can be specified for each papertray.0.0 mmCentering (Duplex2nd Side)Adjust the starting print position between -3.0 and3.0 mm at the left edge of the paper for the sec-ond side during automatic double-sided copying.Adjustments can be specified for each paper tray.0.0 mmFinisher Ad-justmentCenter Staple Po-sition * 1 Adjust the stapling position (between -10 and 10mm) when printing with the "Center Staple & Fold"setting.0Half-Fold Position* 1 Adjust the folding position (between -10 and 12.7mm) when printing with the "Center Staple & Fold"setting.0Punch HorizontalPosition Adjust-ment* 2Adjust the horizontal position of the punchedholes between -10 mm and 10 mm.0Punch Regist LoopSize Adjustment* 2 Adjust the hole-punching shift for double-sidedprinting and outputting cover pages between -4 mm and 4 mm.0Density Ad-justmentThick –Yellow Adjust the image density for printing on thick pa-per or OHP transparencies. The density can beadjusted separately for each color (yellow, ma-genta, cyan and black for a color image and theblack image density). The higher the setting, thedarker the density.Adjust the setting for yellow, magenta, cyan andblack between -5 and +5.Adjust the setting for "Black Image Density" be-tween -2 and +2.0Thick –Magenta 0Thick –Cyan 0Thick –Black 0Black Image Den-sity0Image Stabilization Perform an image stabilization if the image is in-correct, even after the gradation levels have beenadjusted.• Image Stabilization Only:Perform a normal image stabilization.• Initialize + Image Stabilization:Select when a good result was not achievedafter "Image Stabilization Mode" was select-ed.Image Stabilization OnlyColor Regis-tration Ad-justColor RegistrationAdjust (Yellow)Adjust the color registration if color shifts can beseen in the print result.-Color RegistrationAdjust (Magenta)-Color RegistrationAdjust (Cyan)-
