CS193/CS173/CS163 12-51Utility mode 121 Display the Administrator Settings screen.– For details on displaying the Administrator Setting screen, refer to "Displaying the AdministratorSettings screen" on page 12-37.2 Touch [1 System Settings].The System Settings screen appears.3 Touch [7 Expert Adjustment].The Expert Adjustment screen appears.4 Touch [3 Finisher Adjustment].The Finisher Adjustment screen appears.5 Touch [4 Punch Regist Loop Size Adjustment].The Punch Regist Loop Size Adjustment screen appears.6 Check the angle of the punched holes.– If the punched holes are angled, touch [+] to change the adjustment. If the angle cannot be adjustedby touching [+] or if the paper is wrinkled, touch [-] to change the adjustment.– Each time [+] or [-] is touched, the value is increased or decreased by one increment.7 Touch [OK].– To cancel the setting and select the default, press the [Reset] key.The angle of the punched holes is adjusted.If no adjustment of the angle of the punched holes was necessary in step 6, this completes theprocedure.8 Use a Punch setting to print another sample copy.9 Check the print result.– Check that the angle of the punched holes was adjusted.– If more adjustment is necessary, repeat steps 6 and 7.
