CS193/CS173/CS163 12-53Utility mode 12– If the lines are shifted in the X direction as shown below,touch [-] under "X" to reduce the adjustment (between -1dot and -6 dots).– Each time [+] or [-] is touched, the value is increased ordecreased by one increment.– If the lines are shifted in the X direction as shown below,touch [+] under "X" to increase the adjustment (between 1dot and 6 dots).– If the lines are shifted in the Y direction as shown below,touch [-] under "Y" to reduce the adjustment (between -1dot and -6 dots).– If the lines are shifted in the Y direction as shown below,touch [+] under "Y" to increase the adjustment (between 1dot and 6 dots).– If the lines are not shifted from the reference lines, continue with step 10.9 Press the [Start] key.– The adjustment is applied when the [Start] key is pressed. To cancel the adjustment, press the[Reset] key instead of pressing the [Start] key.The adjusted test pattern is printed.10 Check the print result.– If there is no shift between the black and cyan lines, continue with step 11.– If more adjustment is necessary, repeat steps 8 and 9.11 Touch [OK].– To cancel the setting and select the default, press the [Reset] key.
