VarioLink 6022/7522 6-18Copy paper/originals 67 Specify the X and Y sides of the paper, and then touch [OK].– Touch either [X] or [Y], press the [C] (clear) key to clear the current setting, and then use the keypadto type in the size.– If a decimal value is displayed in the Custom Size screen, use the keypad to type in the setting. Fordetails on switching between decimal and fraction values, refer to "System Settings" onpage 11-15.– If the orientation of the loaded paper does not match the sizes specified for "X" and "Y", "Inputerror" appears, even if the values are within the allowable range. In addition, do not enter the samesize for "X" and "Y".– If a decimal value is displayed in the screen and the specified value is outside the allowable range,the message "Input Error" appears. Type a value within the allowable range. If the value wasincorrectly entered, press the [C] (clear) key to erase the value, and then specify the correct value.To cancel changes to the settings, touch [Cancel].8 Touch [OK], and then touch [OK] in the next two screens that appear.The Basic screen appears again.2 NoteThe selected size button is programmed with the entered paper size, so that the paper size is availableto be selected again without being typed in. In addition, the size can be changed.6.2.6 Specifying a paper type for bypass trayIf paper other than plain paper, such as OHP transparencies or special paper, is loaded in bypass tray, besure to change the paper type setting.1 In the Basic screen, touch [Paper].The Paper screen appears.2 Touch the button for the bypass tray.
