VarioLink 6022/7522 11-42Utility mode 11– If the folding position is too far to the right of the center of the paper, touch [-] to reduce theadjustment (between -0.1 mm and -12.8 mm).8 Touch [OK].– To cancel the setting and select the default, press the [Reset] key.The center folding position is adjusted.If the folding position was at the center of the paper in step 7, this completes the procedure.9 Use the "Half-Fold" setting to print another sample copy.10 Check the print result.– Check that the folding position is adjusted to the center of the paper.– If more adjustment is necessary, repeat steps 6 through 9.2 NoteSet the value by mm. Refer to the conversion rate below.1 inch = 25.4 mm11.6.3 Punch Vertical Position AdjustmentThe vertical position of punched holes when printing with a Punch setting can be adjusted for each papersize.2 Note[Punch Vertical Position Adjustment] appears only if optional punch kit is installed on the finisher.For details on the Punch settings, refer to "Punching holes in copies (Punch settings)" on page 2-62.0 Before making any adjustments, use a Punch setting to print a sample copy. Perform the adjustmentwhile checking the sample that was created.1 Display the Administrator Settings screen.– For details on displaying the Administrator Settings screen, refer to "Displaying the AdministratorSettings screen" on page 11-36.2 Touch [1 System Settings].The System Settings screen appears.3 Touch [7 Expert Adjustment].The Expert Adjustment screen appears.4 Touch [5 Finisher Adjustment].The Finisher Adjustment screen appears.5 Touch [3 Punch Vertical Position Adjustment].
