VarioLink 6022/7522 11-48Utility mode 11– Each time [+] or [-] is touched, the value is increasedor decreased by one increment.– To decrease width A, touch [-] to decrease theadjustment (between -0.1 mm and -5.0 mm).7 Touch [OK].– To cancel the setting and select the default, press the [Reset] key.The horizontal position of the punched holes is adjusted.If no adjustment of the horizontal position of the punched holes was necessary in step 6, this completesthe procedure.8 Use a Punch setting to print another sample copy.9 Check the print result.– Check that the horizontal position of the punched holes was adjusted.– If more adjustment is necessary, repeat steps 6 through 9.2 NoteSet the value by mm. Refer to the conversion rate below.1 inch = 25.4 mm11.6.7 Punch Resist Loop Size AdjustmentWhen printing with a Punch setting, the angle of punched holes along the side of the paper can be adjusted.2 Note[Punch Resist Loop Size Adjustment] appears only if optional punch kit is installed on the finisher.For details on the Punch settings, refer to "Punching holes in copies (Punch settings)" on page 2-62.0 Before making any adjustments, use a Punch setting to print a sample copy. Perform the adjustmentwhile checking the sample that was created.1 Display the Administrator Settings screen.– For details on displaying the Administrator Setting screen, refer to "Displaying the AdministratorSettings screen" on page 11-36.2 Touch [1 System Settings].The System Settings screen appears.AA
