VarioLink 6022/7522 1-31Before Making Copies 1? How can the job being printed be stopped?% Press the [Stop] key. For details, refer to "Temporarily stopping scanning/printing" onpage 2-78.!DetailWhile the machine is warming up to begin printing after it is turned on using the [Power] (auxiliary power)key, copy settings can be specified and an original can be scanned to reserve a copy job. After themachine has finished warming up, the copies are automatically printed.The print order can be changed or jobs can be deleted from the Detail screen of a job from the CurrentJobs list in the Job List screen. For details, refer to "Managing jobs" on page 10-2.1.3.3 Turning off the machine1 Press the [Power] (auxiliary power) key.Check that the touch panel is turned off.2 Open the front door, and then set the main powerswitch to "o".3 Close the front door.2 ReminderWhen the machine is turned off, then on again with the main power switch, wait at least 10 seconds toturn the machine on after turning it off. The machine may not operate correctly if it is turned onimmediately after being turned off.Do not turn off the machine with the main power switch or the [Power] (auxiliary power) key while it ismaking copies or printing, otherwise a paper misfeed may occur.Do not turn off the machine with the main power switch or the [Power] (auxiliary power) key while it isscanning or sending or receiving data, otherwise all scan data or transmission data will be deleted.Do not turn off the machine with the main power switch while a queued job or stored data is waiting tobe printed, otherwise the jobs will be deleted.!DetailThe following are cleared when the main power switch and [Power] (auxiliary power) key are turned off.Settings that have not been programmedJobs queued to be printed1.3.4 Automatically clearing settings (automatic panel reset)If no operation is performed for a specified length of time (even if the [Reset] key is not pressed), settings thathave not been programmed, such as the number of copies, are cleared and return to their default settings.This is the automatic panel reset operation.As the factory default, the automatic panel reset operation is performed after 1 minute.
