VarioLink 6022/7522 12-2Authentication Unit (Biometric Type AU-101) 1212 Authentication Unit (Biometric Type AU-101)12.1 Using Authentication Unit (Biometric Type) AU-101The Authentication Unit (Biometric Type) AU-101 is a biometric authentication system that performs userauthentication by scanning vein patterns in a finger. Log on to this machine and print job operation can beauthenticated with finger vein patterns when using this machine with user authentication settings specified.The status of the authentication unit is indicated by a status indicator and tone.In order to use the authentication unit, user finger vein patterns must first be registered with the machine.A registered user can log on to this machine or print a print job after completing authentication with theirfinger vein patterns.The following procedures describe how to specify the necessary settings on the machine, register users, andperform the logon and print job operations after completing authentication.2 NoteAlign the index finger with the indentation and notch in the scanner, and then position the finger so thatthe tip lightly touches the edge of the scanner. Place your thumb and middle finger down to hold theauthentication unit in place on both sides, and avoid moving the index finger being used forauthentication.For details on positioning the finger on the authentication unit, refer to the Quick Guide AuthenticationUnit (Biometric Type AU-101).2 ReminderDo not place any object other than your finger in the scanner of the authentication unit while scanning,otherwise the device may malfunction.Do not disconnect the cable connecting the authentication unit to the computer while scanning,otherwise the system may become unstable.12.1.1 Settings of this machine!DetailUser authentication on the machine must be set for machine authentication.1 From the control panel of the multifunctional product, touch [4 User Authentication/Account Track] onthe Administrator Settings screen, and then touch [1 General Settings].2 Set "User Authentication" to "ON (MFP)", and then touch [OK].– External server authentication is not supported.Status indicator Device statusLit (green) Standing by/authentication completedFlashing (green) Authenticating/scanningLit (red) Authentication failed/scanning failedOff The authentication unit is not detected.Tone Device statusOne short beep Starting to scanOne short beep Retrying after authentication failedOne short beep Authentication completedTwo short beeps Authentication failed
