VarioLink 6022/7522 11-47Utility mode 118 Use a Punch setting to print another sample copy.9 Check the print result.– Check that the horizontal position of the punched holes was adjusted.– If more adjustment is necessary, repeat steps 6 through 9.2 NoteSet the value by mm. Refer to the conversion rate below.1 inch = 25.4 mm11.6.6 Punch Unit Horizontal Position AdjustmentThe horizontal position of punched holes when printing with a Punch setting can be adjusted.2 Note[Punch Unit Horizonal Position Adjustment] appears only if optical Z folding unit is installed.For details on the Punch settings, refer to "Punching holes in copies (Punch settings)" on page 2-62.0 Before making any adjustments, use a Punch setting to print a sample copy. Perform the adjustmentwhile checking the sample that was created.1 Display the Administrator Settings screen.– For details on displaying the Administrator Settings screen, refer to "Displaying the AdministratorSettings screen" on page 11-36.2 Touch [1 System Settings].The System Settings screen appears.3 Touch [7 Expert Adjustment].The Expert Adjustment screen appears.4 Touch [5 Finisher Adjustment].The Finisher Adjustment screen appears.5 Touch [6 Punch Unit Horizontal Position Adjustment].The Punch Unit Horizontal Position Adjustment screen appears.6 Check the horizontal position of the punched holes.– To increase width A, touch [+] to increase the adjustment (between 0.1 mm and 5.0 mm).
