- 182 -5. FaxThis section describes the scan settings for Internet Fax transmissions.If using Scan to Fax Server, the following scan settings are not available.• Setting a reply destination• Editing an e-mail• Specifying a file name (file name)• Scanning a duplex document (duplex scan)Scanning Multiple Documents Continuously (Continuous Scan)You can scan a fax transmission document from the ADF and document glass. For example,you can send a document and a part of a book as a single fax job.1 Press [Fax/Internet Fax] or the (FAX) button.2 Set a document in the ADF or on the document glass.3 Press [Internet Fax].4 Select the [Advanced] tab.5 Press [Continuous Scan].[Continuous Scan] is set to [ON].Pressing [Continuous Scan] switches between [ON] and [OFF].6 Specify a destination.Entering a Destination E-mail AddressSpecifying a Destination from Address Book/Group ListSelecting a Destination Using One Touch ButtonsSelecting a Destination from Transmission HistorySearching for a Destination in the LDAP Server7 Press the (START) button to start scanning the first document.8 When [Please set next document] is displayed, set the next document.9 Press [Start Scan].10 Repeat steps 8 and 9 for each fax transmission document if necessary.11 When scanning all sets of the documents is complete, press [Scan Complete].Adjusting the Density (Density)You can adjust the density in seven levels.1 Press [Fax/Internet Fax] or the (FAX) button.2 Set a document in the ADF or on the document glass.3 Press [Internet Fax].4 Press [Density] on the [Image Settings] tab.5 Select density.• Alternatively, you can set this setting from [Function Settings].• [0] is the standard value. To increase the density, select [+1], [+2], or [+3] (darkest). To decrease the density,select [-1], [-2], or [-3] (lightest).Setting Scanning for Transmission
