- 218 -5. FaxSet an operation type in Ans/Fax Ready mode.1 Press [Device Settings] on the touch panel.2 Press or several times and press [Admin Setup].3 Enter the administrator name and password and press [OK].The factory default administrator name and password are "admin" and "999999"respectively.4 Press [Fax Setup].5 Press [Fax Setting].6 Press or several times and press [TAD Mode].7 Select a type.• [Type 1]: Fax signal detection starts immediately after the answering machine/telephone responds. If the sender is sending a fax, the fax reception startsautomatically.When the answering machine finishes responding, the fax reception starts.If there is a problem with a fax reception, using this type may improve the problem.• [Type 2]: Fax signal detection starts immediately after the answering machine/telephone responds. If the sender is sending a fax, the reception starts automatically.Even after the answering machine finishes responding, the fax reception does notstart.If you usually receive calls, use this type.• [Type 3]: Fax signal detection starts in 15 seconds after the answering machine/telephone responds. If the sender is sending a fax, the reception starts automatically.When the answering machine finishes responding, the fax reception starts.Use this type for normal use.8 Press [Back] until the home screen is displayed.Setting TAD Mode
