Specifications15-2615.5.2 Setting Parameter Control Area●: Available, -: Not availableAxis no.Unitmemoryno. (Hex)Name Default Description R W- UM 00280-UM 00281Number ofwriting toFROMU0Announces the number of writing the positioningparameters and data in the unit memory intoFROM. －- UM 00282 Reservedfor system - - - -- UM 00283 FROM writeresult H0FROM writing in progress : H5555FROM writing ended normally : H0FROM writing ended abnormally : HFFFFFROM writing by CMI in progress: HAAAA －1 UM 00284Recalculation startingtablenumberU1This is used to rewrite positioning data using auser program.Reconstructs the positioning data which startswith the table number specified in this areawhen the recalculation request (Y7) turns on.Range: 1-1000 1 UM 00285Recalculation startingtable sizeU0Reconstructs the positioning data of the tablesize specified in this area when the recalculationrequest (Y7) turns on.Range：1-500 （2-64Virtual 1-32）UM 00286-UM 00343The following areas are allocated to each axis. Recalculation starting table number: 1 word Recalculation starting table size: 1 word - UM 00344-UM 0037FReservedfor system - - - -15.5.3 Operation Speed Rate Area●: Available, -: Not availableAxis no.Unitmemoryno. (Hex)Name Default Description R W1 UM 00380 Operationspeed rate U1All operations relating to axes (positioning, JOGoperation, home return) can be performed at thespecified rate.Range:0-500 [%] (For single axis control)Range:0-200 [%] (For interpolation control) (2-64Virtual 1-32)UM 00381-UM 003DFThe following areas are allocated to each axis. Operation speed rate: 1 word - UM 003E0-UM 003FFReservedfor system - - - -
