Introduction to DBS 576 Programming Section 400-ProgrammingIntro-16 l DBS 576 (USA) issued 05/20/98 576-13-400FF1SystemFF2TrunksFF3ExtensionsFF4FF-/Soft KeysFF5GroupsFF6TRS/ARS0 SystemConfigurationFF7ApplicationsFF8MaintenanceIntroductionAppendix AAppendix BFF1SystemFF2TrunksFF3ExtensionsFF4FF-/Soft KeysFF5GroupsFF6TRS/ARS0 SystemConfigurationFF7ApplicationsFF8MaintenanceIntroductionAppendix AAppendix BFF-Keys and Other Keys Used in Programming ModeWhile in Programming Mode, the phone keys can perform special functions such ascopying, scrolling, etc. The following illustrations describe these keys and theirfunctions during Programming Mode on each type of phone.Figure Intro-1: Phone keys during Programming Mode (22-button Large-Display)IMPORTANT: A display phone is required for key programming.A Large-Display phone is recommended because of the automaticdisplay of One-Touch Key (1-10) functions. PROGRAM V1.0 SpeakerphoneABC DEFGHI JKL MNOPRS TUV WXY (22-button Large-Display phone shown)Copies settings of displayed trunk/ext. port or FF-key.Pastes settings to the current trunk/ext.port or FF-key.(no effect)Scrolls through ports in descending order (9, 8, 7,...).Scrolls through ports in ascending order (1, 2, 3,...). (no effect) Moves tothe settingin certainFF4, FF7and FF8addresses.(no effect) (no effect) (no effect) Goes back tobeginning ofProgrammingMode. Clears incorrect dialing, and backs out to the previousmenu level. Or, if you've entered an incorrect setting,press REDIAL (instead of HOLD) to re-display theprevious setting.Backs out to the previous menu level.First button dialed to enter Programming Mode.Or, exits Programming Mode.(no effect) Clears thedisplayedsetting.Saves the displayedsetting, and movesto the next address.Or (at menu level)moves to the nextsub-menu, goingdeeper into thesame menu.Scrolls throughaddress numbers:in ascending order(1, 2, 3,...).in descending order(9, 8, 7, ...) Prints data setting.(no effect)Inserts a dash "-" into a speed-dial no.Inserts a pause into a speed-dial no.Inserts a "don't-access-trunk-line"message into a speed-dial no. FF1: to System ProgrammingFF2: to Trunk ProgrammingFF3: to Extension Programmingetc.NOTE: To enter 0: System Configuration, dial "0".
