Section 400-Programming 0: System Configuration576-13-400 DBS 576 (USA) issued 05/20/98 l Page 0-3FF1SystemFF2TrunksFF3ExtensionsFF4FF-/Soft KeysFF5GroupsFF6TRS/ARS0 SystemConfigurationFF7ApplicationsFF8MaintenanceIntroductionAppendix AAppendix BFF1SystemFF2TrunksFF3ExtensionsFF4FF-/Soft KeysFF5GroupsFF6TRS/ARS0 SystemConfigurationFF7ApplicationsFF8MaintenanceIntroductionAppendix AAppendix BBefore Removing a Trunk or Extension Card from a Free SlotFirst clear the Trunk Numbers or Extension Numbers assigned to the ports on the card in programming.This is for system “housecleaning” purposes, so the numbers can be automatically removed from otherareas in programming such as Hunt Groups, etc.Addresses for Trunk Cards:Trunk Numbers for analog CO trunks: FF2 0 BSSC 00 Hold (0-576) Hold (pg. 2-7)(LTRK/8, LGTRK8, DIDTR8)Trunk Numbers for analog E&M tie trunks: FF2 0 BSSC 00 Hold (0-576) Hold (pg. 2-37)(E&M/4)Trunk Numbers for ISDN trunks: FF2 1 BSSC 01 Hold (0-576) Hold (pg. 2-60)(TBRI/4, PRI/8, PRI/16, PRI/23)Trunk Numbers for T1 trunks: FF2 2 BSSCC 01 Hold (0-576) Hold (pg. 2-87) --CO(T1/8, T1/16, T1/24) FF2 2 BSSCC 01 Hold (0-576) Hold (pg. 2-116) --E&MAddresses for Extension Cards:Extension Numbers for digital or SLT phones: FF3 0 BSSC 02 Hold (0-9999) Hold (pg. 3-4)(DEC/8, AEC/8)Extension Numbers for ISDN extensions: FF3 1 BSSC 01 Hold (0-9999) Hold (pg. 3-29)(SBRI/4, PRI/8, PRI/23)Using the LS/GS Card for Ground-StartIn order to use the Loop-Start/Ground-Start Trunk Card (LGTRK8) for ground-start signaling:r A pair of jumpers for each circuit must be installed on the card.r A -48V power supply must be installed in the cabinet.r Ground lead on power supply must be installed properly (“SG” connected to Ground screw).See Section 300-Installation for more information.Installing the API Card for PanaVOICEThe API Card is required if PanaVOICE (proprietary Voice Mail) is installed. When configuring theFree Slot for the API Card, use Card Type address numbers 80-87 (see table, pg. 0-7).r Not more than one API Card can be installed per cabinet.r The API Card can be installed in any Free Slot between 01 and 11.r A DEC or AEC Card, which can provide up to 8 voice ports, must also be installed in the Free Slotimmediately after (to the right of) the API Card.r If the API Card doesn’t use all 8 ports on the DEC or AEC for voice mail, the remaining ports can beused for normal extensions.The API Card will always choose Port #8 (last port) on the DEC or AEC as the 1st voice port. The 2ndvoice port is always Port #7 on the DEC/AEC; the 3rd voice port #6; etc. See illustration (next page).
