Section 400-Programming FF1: System Programming576-13-400 DBS 576 (USA) issued 05/20/98 l Page 1-29FF1SystemFF2TrunksFF3ExtensionsFF4FF-/Soft KeysFF5GroupsFF6TRS/ARS0 SystemConfigurationFF7ApplicationsFF8MaintenanceIntroductionAppendix AAppendix BFF1SystemFF2TrunksFF3ExtensionsFF4FF-/Soft KeysFF5GroupsFF6TRS/ARS0 SystemConfigurationFF7ApplicationsFF8MaintenanceIntroductionAppendix AAppendix BNotes:Related Programming:Trunk COS: Paging on DISA/Tie-Line Call (pg. 1-78) FF1 0 04 (00-15) 05 Hold (0 or 1) HoldFF2 0: Analog Trunks (E&M Tie) (pg. 2-37)FF2 2: T1 Trunks (E&M Tie) (pg. 2-116)Notes:Howler Tone: A loud tone issued through the handset receiver to call attention to an off-hook/dial-tonecondition (for example, when a user fails to hang up from a call).Related Programming:Extension COS: Dial Tone Pre-Pause Check (pg. 1-65) FF1 0 03 (00-15) 39 Hold (0 or 1) HoldPre-Pause Timer at Internal Dial Tone (DP SLTs) (pg. 1-139) FF1 1 03 0003 Hold (0-255) HoldPre-Pause Timer at Internal Dial Tone (DTMF SLTs) (pg. 1-140) FF1 1 03 0004 Hold (0-255) HoldPre-Pause Timer at Internal Dial Tone (Digital Keyphones) (pg. 1-140) FF1 1 03 0005 Hold (0-255) HoldInterdigit Timer (Digital Keyphones) (pg. 1-142) FF1 1 03 0008 Hold (0-255) HoldHowler Tone Duration Timer (Extensions) (pg. 1-153) FF1 1 04 0016 Hold (0-255) HoldPaging Answer on Tie-Line(all CPCs) - Version 1.0 or higherSet whether the system receiving the page will send back an answer signalto the system originating the page, on an E&M tie-line.FF1 0 02 0013 Hold (0 or 1) Hold0=No answer signal. (default)1=Answer signal is sent to the originating system.% * $ #)%Howler Tone(all CPCs) - Version 1.0 or higherEnable/Disable Howler Tone.FF1 0 02 0014 Hold (0 or 1) Hold0=Disable Howler Tone. (default)r1=Enable Howler Tone..!;, %!
