FF2: Trunk Programming (T1 E&M Tie) Section 400-ProgrammingPage 2-116 l DBS 576 (USA) issued 05/20/98 576-13-400FF1SystemFF2TrunksFF3ExtensionsFF4FF-/Soft KeysFF5GroupsFF6TRS/ARS0 SystemConfigurationFF7ApplicationsFF8MaintenanceIntroductionAppendix AAppendix BFF1SystemFF2TrunksFF3ExtensionsFF4FF-/Soft KeysFF5GroupsFF6TRS/ARS0 SystemConfigurationFF7ApplicationsFF8MaintenanceIntroductionAppendix AAppendix B2.FF2 2: T1 Trunks (E&M Tie)NOTE: These settings apply to point-to-point network trunks (connectionsbetween 2 or more switches). For “CO” T1 trunk programming, go topg. 2-86.Notes:The remaining addresses in this T1 Trunks (E&M Tie) section will apply if the T1 trunk is set to2=Private Network in the above address. If 1=CO (default) is chosen instead, go to pg. 2-86.Choose 1=CO (and follow the addresses starting on pg. 2-86) if the carrier is providing DID/DNIStrunks with E&M signaling.Related Programming:Trunk Connection Type (CO/PBX) (pg. 2-127) FF2 2 BSSCC 03 03 Hold (0 or 1) HoldTrunk Connection Type (CO/Network)(all CPCs) - Version 1.0 or higherSet whether the T1 channel is connected to the CO or to a private network.FF2 2 BSSCC 00 Hold (1-2) HoldBSSCC: T1 (E&M Tie) Channel PositionB=Cabinet no. 1-6SS=Slot no. 01-12CC=Channel no. 01-241=CO (default)2=Private Network (E&M) $%3 %6 #0)*%Trunk Number Assignment(all CPCs) - Version 1.0 or higherAssign a trunk number to each T1 channel.FF2 2 BSSCC 01 Hold (0-576) HoldTrunk Number 1-576BSSCC: T1 (E&M Tie) Channel PositionB=Cabinet no. 1-6SS=Slot no. 01-12CC=Channel no. 01-24 default: [no assignment](0 = no trunk) $%-4 )-8(or BLK-DOWN)
