Section 400-Programming FF2: Trunk Programming (Analog CO)576-13-400 DBS 576 (USA) issued 05/20/98 l Page 2-13FF1SystemFF2TrunksFF3ExtensionsFF4FF-/Soft KeysFF5GroupsFF6TRS/ARS0 SystemConfigurationFF7ApplicationsFF8MaintenanceIntroductionAppendix AAppendix BFF1SystemFF2TrunksFF3ExtensionsFF4FF-/Soft KeysFF5GroupsFF6TRS/ARS0 SystemConfigurationFF7ApplicationsFF8MaintenanceIntroductionAppendix AAppendix BNotes:If this address is left at “0=Synchronize with CO (default),” and the trunk is set for DID/DISA in RingType, the system will use Ring Pattern 1 (1 second on / 3 seconds off).If Trunk COS: Incoming Ring Tone Source (pg. 1-75) is set to “0=Use trunk’s Ring Pattern(default),” the above Ring Pattern will apply to all incoming-call types: multiple incoming, DIL, DID,DISA. However, if the Ring Tone Source is set to “1=Use intercom ring tone,” the above Ring Patternwill apply only to multiple-incoming calls.Related Programming:Trunk COS: Incoming Ring Tone Source (pg. 1-75) FF1 0 04 (00-15) 01 Hold (0 or 1) HoldTrunk COS Assignment (pg. 2-35) FF2 0 BSSC 07 Hold (1-16) HoldRing Type/Destination for analog CO trunks (pg. 2-28) FF2 0 BSSC 03 (0 thru 5) Hold...FF4 0: FF-Keys on Digital Keyphones, SLTs, and EM/24 Units (pg. 4-7)FF4 1: FF-Keys on DSS/72 Consoles (pg. 4-14)Ring Pattern(all CPCs) - Version 1.0 or higherSet the ring pattern for incoming calls on this trunk.FF2 0 BSSC 01 12 Hold (0-12) HoldSetting Values for U.K. Setting Values for U.S. and Hong Kong0 Synchronize with CO 0 Synchronize with CO (default)1 1on/2off (default) (in seconds) 1 1on/3off (in seconds)2 2on/1off 2 2on/2off3 1on/1off 3 3on/1off4 .5on/.5off 4 1on/1off5 .25on/2.75off 5 .5on/.5off6 .25on/.25off/.25on/2.25off 6 .5on/3.5off7 .25on/.25off/.25on/.25off/.25on/1.75off 7 .5on/.5off/.5on/2.5off8 .75on/.25off/.75on/1.25off 8 .25on/.25off/.25on/3.25off9 1on/.25off/.25on/1.5off 9 1on/.25off/.25on/2.5off10 1on/.25off/.25on/.25off/.25on/1off 10 1on/.25off/.25on/.25off/.25on/2off11 1.375on/.125off/.125on/.125off/.125on/.125off 11 1.375on/.125off/.125on/.125off/.125on/.125off12 Continuous tone 12 Continuous toneBSSC: Analog (CO) Trunk PositionB=Cabinet no. 1-6SS=Slot no. 01-12C=Circuit no. 1-8 $ ', $%)
