Section 400-Programming FF3: Extension Programming576-13-400 DBS 576 (USA) issued 05/20/98 l Page 3-21FF1SystemFF2TrunksFF3ExtensionsFF4FF-/Soft KeysFF5GroupsFF6TRS/ARS0 SystemConfigurationFF7ApplicationsFF8MaintenanceIntroductionAppendix AAppendix BFF1SystemFF2TrunksFF3ExtensionsFF4FF-/Soft KeysFF5GroupsFF6TRS/ARS0 SystemConfigurationFF7ApplicationsFF8MaintenanceIntroductionAppendix AAppendix BNotes:MCO Prime Line: When the user picks up the handset (ON/OFF not affected; it always gets intercomdial tone), the 1st-priority MCO group is picked up automatically.Related Programming:FF1 3: MCO Access in Tenant Groups (pg. 1-163)Notes:Account Codes: The user dials the feature code for Account Code Entry (#8 by default), the AccountCode (1-10 digits long), and # before dialing an outbound call. Or, during an inbound call, the user dialsAUTO # [Account Code] #. Account Codes are useful for allocating telephone expenses on SMDRreports. They are also useful (as Forced, Not Forced, Verified, or Unverified) for overriding theextension’s TRS Class for outbound calls that are “exceptions to the rule,” as shown in the table below:MCO Prime Line(all CPCs) - Version 1.0 or higherEnable/Disable the MCO Prime Line feature on the extension.FF3 0 BSSC 04 23 Hold (0 or 1) HoldBSSC: Extension PortB=Cabinet no. 1-6SS=Slot no. 01-12C=Circuit no. 1-80=Disable MCO Prime Line. (default)1=Enable MCO Prime Line. $ 2# $ 'Forced Account Codes(all CPCs) - Version 1.0 or higherEnable/Disable “Forced” entry of Account Codes for calls on this extension.FF3 0 BSSC 04 24 Hold (0 or 1) HoldBSSC: Extension PortB=Cabinet no. 1-6SS=Slot no. 01-12C=Circuit no. 1-80=Disabled/Not Forced (default)1=Enabled/Forced $ "!' /
