0: System Configuration Section 400-ProgrammingPage 0-6 l DBS 576 (USA) issued 05/20/98 576-13-400FF1SystemFF2TrunksFF3ExtensionsFF4FF-/Soft KeysFF5GroupsFF6TRS/ARS0 SystemConfigurationFF7ApplicationsFF8MaintenanceIntroductionAppendix AAppendix BFF1SystemFF2TrunksFF3ExtensionsFF4FF-/Soft KeysFF5GroupsFF6TRS/ARS0 SystemConfigurationFF7ApplicationsFF8MaintenanceIntroductionAppendix AAppendix BFigure 0-3: Cabinet SlotsNotes:“MFR/8” (DTMF Receiver cards) cannot be automatically detected by the system. You must manuallyassign them in this address.Typically, Option Slots are used for SCC (Service Control cards) or TSW (Time Switch cards), whichdo not require a code assignment.Related Programming:Card Reset (pg. 8-23) FF8 0 04 0 BSS Hold (0 or 1) (Flash + Hold)Card Type Verification (pg. 8-23) FF8 0 04 1 BSS 00 Hold [01-99 displays]Card Version Verification (pg. 8-24) FF8 0 04 1 BSS 01 Hold [Version No. displays]T1 Loopback 1 Diagnostics (pg. 8-34) FF8 0 05 3 BSS(C) Hold (0 or 1) HoldT1 Loopback 2 Diagnostics (pg. 8-34) FF8 0 05 4 BSS(C) Hold 1 HoldOption SlotsCPCCard Free Slots Option Slot Assignment(all CPCs) - Version 1.0 or higherEnter the type of card installed in each of the two Option Slots in the cabinet.02 (1-6) (13 or 14) Hold (50) HoldCard Type No. 50 (for MFR/8)13=”OP1” option slotCabinet No. 1-614=”OP2” option slot ! #$
