Section 400-Programming FF1: System Programming576-13-400 DBS 576 (USA) issued 05/20/98 l Page 1-35FF1SystemFF2TrunksFF3ExtensionsFF4FF-/Soft KeysFF5GroupsFF6TRS/ARS0 SystemConfigurationFF7ApplicationsFF8MaintenanceIntroductionAppendix AAppendix BFF1SystemFF2TrunksFF3ExtensionsFF4FF-/Soft KeysFF5GroupsFF6TRS/ARS0 SystemConfigurationFF7ApplicationsFF8MaintenanceIntroductionAppendix AAppendix BFF1 0 03: Extension COS DefinitionsNOTE: Based on their initial default values, Extension Class of Service (COS)No. 15 (setting “14” in the addresses below) is intended for Built-In Voice Mailand Built-In ACD ports. Extension COS No. 16 (setting “15”) is intended forAttendant phones. If the default for these COS Nos. is different from the normaldefault, it will be indicated in the address explanations on the following pages.When you enter the address number 00-15 for the desired COS No. 01-16, theactual COS No. (01-16) will appear on the phone’s display.By default, all extensions are assigned to Extension COS No. 1 (see FF3 0 BSSC07 on pg. 3-26).Table 1-2. Extension COS addresses and defaultsFF1 0 03 (00-15) 01 Hold (0 or 1) Hold Extension COS: Intercom Calling Type 1 (Voice) pg. 1-36FF1 0 03 (00-15) 02 Hold (0 or 1) Hold Extension COS: Onhook Transfer at Ringback 0 (Allowed) pg. 1-37FF1 0 03 (00-15) 03 Hold (0 or 1) Hold Extension COS: Onhook Transfer at Talk 0 (Allowed) pg. 1-38FF1 0 03 (00-15) 04 Hold (0 or 1) Hold Extension COS: Onhook Transfer at Camp-On 0 (Allowed) pg. 1-39FF1 0 03 (00-15) 05 Hold (0 or 1) Hold Extension COS: Exclusive Hold for Non-Appearing CO0 (System Hold) pg. 1-40FF1 0 03 (00-15) 06 Hold (0 or 1) Hold Extension COS: Exclusive Hold on SLTs 0 (System Hold) pg. 1-41FF1 0 03 (00-15) 07 Hold (0 or 1) Hold Extension COS: Brokers Hold on SLTs 1 (Broker’s Hold) pg. 1-42FF1 0 03 (00-15) 08 Hold (0 or 1) Hold Extension COS: Hookflash Control on SLTs 0 (Allowed) pg. 1-43FF1 0 03 (00-15) 09 Hold (0 or 1) Hold Extension COS: SSD Assignment 1 (Not Allowed) pg. 1-43FF1 0 03 (00-15) 10 Hold (0 or 1) Hold Extension COS: SSD Assignment to MCOTenant Groups1 (Not Allowed) pg. 1-44FF1 0 03 (00-15) 11 Hold (0 or 1) Hold Extension COS: SSD Dialing 0 (Allowed) pg. 1-45FF1 0 03 (00-15) 12 Hold (0 or 1) Hold Extension COS: Intercom Redialing 1 (Not Allowed) pg. 1-46FF1 0 03 (00-15) 13 Hold (0 or 1) Hold Extension COS: Direct Trunk Access 0 (Allowed) pg. 1-46FF1 0 03 (00-15) 14 Hold (0 or 1) Hold Extension COS: MCO Incoming Call Answer 0 (Allowed) pg. 1-47FF1 0 03 (00-15) 15 Hold (0 or 1) Hold Extension COS: Paging 0 (Allowed) pg. 1-48FF1 0 03 (00-15) 16 Hold (0 or 1) Hold Extension COS: Auto Repeat Dial 0 (Allowed) pg. 1-48FF1 0 03 (00-15) 17 Hold (0 or 1) Hold Extension COS: DND Set/Clear 0 (Allowed) pg. 1-49FF1 0 03 (00-15) 18 Hold (0 or 1) Hold Extension COS: DND Set/Clear (Other) 1 (Not Allowed) pg. 1-50FF1 0 03 (00-15) 19 Hold (0 or 1) Hold Extension COS: Call Forward/All Calls 0 (Allowed) pg. 1-50FF1 0 03 (00-15) 20 Hold (0 or 1) Hold Extension COS: Call Forward/No Answer 0 (Allowed) pg. 1-51FF1 0 03 (00-15) 21 Hold (0 or 1) Hold Extension COS: Call Forward/Busy 0 (Allowed) pg. 1-52FF1 0 03 (00-15) 22 Hold (0 or 1) Hold Extension COS: Call Forward/Other 1 (Not Allowed) pg. 1-52FF1 0 03 (00-15) 23 Hold (0 or 1) Hold Extension COS: User Log-In 1 (Not Allowed) pg. 1-53FF1 0 03 (00-15) 24 Hold (0 or 1) Hold Extension COS: Priority Message Waiting Send(VM)1 (Not Allowed) pg. 1-54FF1 0 03 (00-15) 25 Hold (0 or 1) Hold Extension COS: Message Waiting Send 0 (Allowed) pg. 1-55FF1 0 03 (00-15) 26 Hold (0 or 1) Hold Extension COS: System Mode Switch 1 (Not Allowed) pg. 1-55FF1 0 03 (00-15) 27 Hold (0 or 1) Hold Extension COS: Busy Override Send 0 (Allowed) pg. 1-56
