Introduction to DBS 576 Programming Section 400-ProgrammingIntro-20 l DBS 576 (USA) issued 05/20/98 576-13-400FF1SystemFF2TrunksFF3ExtensionsFF4FF-/Soft KeysFF5GroupsFF6TRS/ARS0 SystemConfigurationFF7ApplicationsFF8MaintenanceIntroductionAppendix AAppendix BFF1SystemFF2TrunksFF3ExtensionsFF4FF-/Soft KeysFF5GroupsFF6TRS/ARS0 SystemConfigurationFF7ApplicationsFF8MaintenanceIntroductionAppendix AAppendix BSample Address EntriesThere are several different ways to enter the same address. You can eitherstep through each menu level, or enter all address numbers sequentially toreach the data entry level in the address -- or a combination of both:Table Intro-3. Sample Programming AddressesTo perform this function...Press...... and the phone willdisplay:Enter Programming Mode:NOTE: “NNNN” is the Dealer Programming ID Code.ON/OFF + PROG + **+ NNNN PROGRAM V1.01 HTo allow extensions to pick up intercom voice calls on other extensions ...reference: Intercom Voice Call Pickup-- FF1 0 02 0005 Hold (0 or 1) Hold(page 1-24 in FF1: SYSTEM PROGRAMMING)to “step through” the menus to the setting: FF1 1System Data002 + Hold 10-02-System Func 20005 + Hold 0005 : 0Pick-up V-callto change the setting to “Allow”: 1 0005 : 1Pick-up V-callto save the setting and move to the next address: Hold 0006 : 1Pick-up BLF-- or --to go directly to the data entry level in the address: 1 + 002 + 0005 + Hold 0005 : 0Pick-up V-callto reset to “Allow” and move to the next address: 1 + Hold 0006 : 1Pick-up BLFAn example of key functions during Trunk programming ...reference: Day1 Delayed Ring Type-- FF2 0 BSSC 04 0 Hold (0-4) Hold(page 2-31 in FF2: TRUNKS)To enter Analog CO Trunk addresses: 2 + 0 + Hold 20-Analog TrunkTo automatically go to the first analog CO trunk port(Cabinet 2, Slot 10, Port 1 in this example):Hold 20-2101-Analog COTo go to Trunk Number data setting: Hold 2101-00 :25Trunk NumberTo back out of the data setting: AUTO 20-2101-Analog COTo go to the Delayed Ring Assignments sub-menu: 4 + Hold 2101-04*Delayed RingTo go to Day1 Delayed Ring Type for port position2101 (first address in this sub-menu):Hold 2101-040 :1Day1 D-Ring Typ
