Chapter 4 Settings — [PROJECTOR SETUP] menu116 - ENGLISH[EXTERNAL CONTROL]Transmits the Light ID signal set by the user.Select this item when the Light ID signal transmitted by the projector is switched using the contentslist distribution function or the Light ID control function of the “Multi Monitoring & Control Software”.To set the Light ID, it is necessary to purchase the Light ID. To purchase the Light ID, visit thePanasonic website (https://panasonic.net/cns/LinkRay/).The Light ID which the user has set is erased in following cases.f When the switched is set to [INTERNAL ID]Transmits the internal Light ID signal.The internal Light ID signal is linked to the Panasonic website (https://panasonic.net/cns/projector/).When the Light ID is set while [LightID] is set to [INTERNAL ID], the Light ID signal set by the user istransmitted.Notef When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [LIGHT POWER] is set to anything other than [NORMAL], the[LightID] setting is disabled and fixed to [OFF].f The light output is decreased when [LightID] is set to anything other than [OFF].When clogging of the filter is detected and the brightness of the light source is restricted, [LightID] will be fixed to [OFF].f Following setting will be disabled and it will be fixed to [OFF] when [LightID] is set to anything other than [OFF].g The [PICTURE] menu → [DYNAMIC CONTRAST]g The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [AMBIENT LIGHT DETECTION] and [SIGNAL DETECTION]f To set the Light ID signal, use “Multi Monitoring & Control Software”. The software can be downloaded from the Panasonic website (https://panasonic.net/cns/projector/).f When the [PROJECTOR SETUP] menu → [INITIALIZE] → [ALL USER DATA] is executed, the [LightID] setting is reset to the factory default.f For details of the contents list distribution function and Light ID control function of “Multi Monitoring & Control Software”, refer to theOperating Instructions of “Multi Monitoring & Control Software”.f The projected image may flicker when the Light ID signal is transmitted, but this is caused luminance change during the transmission of theLight ID, and it is not a malfunction.f When clogging of the filter is detected and the brightness of the light source is restricted, the filter indicator lights up and [LightID]is set to [OFF], and the Light ID signal will not be transmitted. Set it again after cleaning the clogged filter.For details on how to solve the filter clogging, refer to “When an indicator lights up” (x page 196).[INITIAL STARTUP]Set the startup method when the switch is set to .1) Press as to select [INITIAL STARTUP].2) Press qw to switch the item.f The items will switch each time you press the button.[LAST MEMORY] Starts up the projector in the condition before the switch is set to .[STANDBY] Starts up the projector in standby.[ON] Starts projecting immediately.[STARTUP INPUT SELECT]Set the input when the projector is switched on to start projection.1) Press as to select [STARTUP INPUT SELECT].2) Press the button.f The [STARTUP INPUT SELECT] screen is displayed.3) Press asqw to select the input, and press the button.[LAST USED] Keeps the input selected last.[RGB1] Sets the input to RGB1.[RGB2] Sets the input to RGB2.[VIDEO] Sets the input to VIDEO.[HDMI1] Sets the input to HDMI1.[HDMI2] Sets the input to HDMI2.[DIGITAL LINK] Sets the input to DIGITAL LINK.[MEMORY VIEWER] Sets the input to MEMORY VIEWER.[Panasonic APPLICATION] Sets the input to Panasonic APPLICATION.[MIRRORING]*1 Sets the input to MIRRORING.
