Chapter 4 Settings — [NETWORK/USB] menu140 - ENGLISH[SIGNAL QUALITY][SIGNAL QUALITY] is a numerical value of the amount of error, and the display color changes togreen, yellow, or red depending on that value.Check the signal quality level while receiving a signal from the twisted-pair-cable transmitter.f [MAX]/[MIN]: Maximum/minimum value of the amount of errorf Green (-12 dB or lower) → normal signal quality level.f Yellow (-11 to -8 dB) → caution level that noise may appear on the screen.f Red (-7 dB or more) → abnormal level that synchronization is disrupted or not possible to receive.[DIGITAL LINK MENU]When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connectedto the terminal, the main menu of the connected DIGITAL LINK output supported device isdisplayed. Refer to the Operating Instructions of the DIGITAL LINK output supported device for details.Notef When the [NETWORK/USB] menu → [NETWORK CONTROL] → [EXTRON XTP] is set to [ON], [DIGITAL LINK MENU] cannot be selected.[WIRED LAN]Perform the connection setting to use the wired LAN.1) Press as to select [WIRED LAN].2) Press the button.f The [WIRED DETAILED SETUP] screen is displayed.3) Press asqw to select an item, and change the setting according to the operation instruction of themenu.[DHCP][ON]Select this item when there is a DHCP server in the networkthe projector is to be connected, and to acquire the IP addressautomatically.[OFF] Select this item when there is no DHCP server in the network theprojector is to be connected, and to specify the IP address.[IP ADDRESS] Enter the IP address when [DHCP] is set to [OFF].[SUBNET MASK] Enter the subnet mask when [DHCP] is set to [OFF].[DEFAULT GATEWAY] Enter the default gateway address when [DHCP] is set to [OFF].[DNS1] Enter the address of the preferred DNS server when [DHCP] is set to [OFF].[DNS2] Enter the address of the alternate DNS server when [DHCP] is set to [OFF].[EAP]Select the EAP set for the RADIUS server. If the EAP is not set, set to [NONE].The types of EAP that can be selected are as follows.[PEAP(MS-CHAPv2)], [PEAP(GTC)], [EAP-TTLS(MD5)], [EAP-TTLS(MS-CHAPv2)], [EAP-FAST(MS-CHAPv2)], [EAP-FAST(GTC)], [EAP-TLS][USER NAME]Enter the user name to be used for authentication in single-byte alphanumeric characters (excludingthe space). (Maximum of 64 characters)This can be set when [EAP] is set to anything other than [NONE].[PASSWORD]Enter the password to be used for authentication in single-byte alphanumeric characters. (Maximumof 64 characters)This can be set when [EAP] is set to anything other than [NONE].4) Once the setting change is completed, press as to select [STORE], and press the button.f The confirmation screen is displayed.f When [INVALID ENTRY. PLEASE RE-ENTER.] is displayed, change the setting to correct content.5) Press qw to select [OK], and press the button.Notef For setting content of each item, consult the network administrator.f When using EAP, the projector is required to be set according to the RADIUS server setting. For the RADIUS server setting, confirm with thenetwork administrator.f Wired LAN and wireless LAN cannot be used in the same segment.f When using the projector by setting [DHCP] to [ON], confirm that the DHCP server is operating.r Factory default settingf Following is preset as the factory default setting.
