Chapter 4 Settings — [POSITION] menuENGLISH - 912) Press the button.f The [ZOOM] screen is displayed.3) Press as to select [MODE].4) Press qw to switch the item.[INTERNAL] Enlarges the size within the aspect range set with [SCREEN FORMAT].[FULL] Enlarges or reduces the size using the entire display area set with [SCREEN FORMAT].5) Press as to select [INTERLOCKED].6) Press qw to switch the item.[OFF] Sets the [VERTICAL] and [HORIZONTAL] zoom ratio.[ON] Uses [BOTH] to set zoom ratio. Image can be enlarged or reduced vertically and horizontally at thesame magnification.7) Press as to select [VERTICAL] or [HORIZONTAL].f If [ON] is selected, select [BOTH].8) Press qw to adjust.Notef When the [POSITION] menu → [ASPECT] is set to anything other than [NORMAL], [MODE] is not displayed.f [ZOOM] cannot be adjusted when the input is MEMORY VIEWER, Panasonic APPLICATION, or MIRRORING.[CLOCK PHASE]You can adjust the image to achieve an optimal image when there is a flickering image or smeared outlines.1) Press as to select [CLOCK PHASE].2) Press qw or the button.f The [CLOCK PHASE] individual adjustment screen is displayed.3) Press qw to adjust.f Adjustment value will change between [0] and [+31]. Adjust the image so that the amount of interference isat a minimum.Notef Adjustment may not be possible depending on the signal.f There may be no optimal value if the output from the input computer is unstable.f There may be no optimal value when the total dot number is shifted.f [CLOCK PHASE] can be adjusted only when the YCBCR /YPBPR signal or the analogRGB signal is input to the terminal or the terminal.f [CLOCK PHASE] cannot be adjusted when a digital signal is input.f The adjustment value will change to [0] when w is pressed while it was at [+31]. Also, the adjustment value will change to [+31] when q ispressed while it was at [0].[REALTIME KEYSTONE]The keystone distortion that occurs when the projector is installed tilted is adjusted automatically.1) Press as to select [REALTIME KEYSTONE].2) Press qw to select the item to adjust.[OFF] The real-time keystone distortion correction function is not executed automatically.[ON] The real-time keystone distortion correction function is executed automatically.Notef The keystone distortion may not be corrected fully depending on the installation condition. In such case, adjust it with the [POSITION] menu→ [SCREEN ADJUSTMENT].f [REALTIME KEYSTONE] cannot be set in following cases.g When the [PROJECTOR SETUP] menu → [PROJECTION METHOD] → [FLOOR/CEILING] is set to [CEILING]
