|
Chapter 5 Operations — Projecting with Panasonic APPLICATION input178 - ENGLISHProjecting with Panasonic APPLICATION inputUsing the Panasonic application, the image sent from a device connected via LAN can be displayed as aprojected image.Application that can be usedThe image transfer application software used for Panasonic APPLICATION input are as follows.f Wireless Manager ME6.4f Plug and Sharef Wireless Projector for iOS, Wireless Projector for AndroidNotef For details of the installation method of the application software, connection method to the projector, and operation method, refer to thePanasonic website (https://panasonic.net/cns/projector/).f “Plug and Share” allows to write the connection information between the image transfer application software “Plug and Share”, and theprojector and the USB memory by attaching the USB memory to the terminal of the projector. By connecting thispaired USB memory to the USB terminal of the Windows computer or Mac, “Plug and Share” will automatically start up and perform theconnection operation to the projector. For details on the pairing method, refer to “Using the pairing function” (x page 193).Connecting the device1) Press the button to switch the input to Panasonic APPLICATION.f Every time the button is pressed, the input will switch in the order of MEMORYVIEWER, Panasonic APPLICATION, and MIRRORING. Press the button until the inputswitches to Panasonic APPLICATION.f The standby screen is displayed once the input is switched to Panasonic APPLICATION.f The standby screen differs depending on the setting in the [NETWORK/USB] menu → [WIRELESS LAN].For details on the standby screen, refer to “Description of the standby screen” (x page 179).2) Connect the device with the image transfer application software started to the projector.f The image sent to the projector by the operation on the device is displayed as the projected image.Notef For details of the connection method to the projector using the application software, refer to the Operation Instruction of each applicationsoftware.f When the button on the remote control or the button on the control panel is pressed whiledisplaying the image from the device, the information such as the network ID, the projector name, or the QR code is displayed on thescreen. For details of these information, refer to “Description of the standby screen” (x page 179).Ending the connection with the device1) Perform disconnection process in the device side.f Once the connection is disconnected, the standby screen is displayed.Notef It may take some time for the standby screen to display when the connection is ended forcefully by turning off the device, etc., withoutperforming an appropriate disconnection process.
|
