Chapter 4 Settings — [PICTURE] menuENGLISH - 87Operation Adjustment Range of adjustmentPress w. The intermediate tome becomes brighter. -8 - +7Press q. The intermediate tone becomes darker.[DAYLIGHT VIEW]You can correct the image to the optimal vividness even if it is projected under a bright light.1) Press as to select [DAYLIGHT VIEW].2) Press qw or the button.f The [DAYLIGHT VIEW] individual adjustment screen is displayed.3) Press qw to switch the item.f The items will switch each time you press the button.[AUTO] Detects the brightness of the installed environment by the luminance sensor, and automaticallycorrects the vividness of the image.[OFF] No correction.[1] Corrects the image to weaken vividness.[2] Corrects the image to medium vividness.[3] Corrects the image to high vividness.Notef [AUTO] cannot be selected when the [PROJECTOR SETUP] menu → [FRONT/REAR] of [PROJECTION METHOD] is set to [REAR].f The luminance may not be detected correctly when an object is placed on top of the projector, blocking the luminance sensor. In such acase, this function may not operate properly even if it is set to [AUTO].f When the [PICTURE] menu → [PICTURE MODE] is set to [DICOM SIM.], the factory default value is [OFF].[SHARPNESS]You can adjust the sharpness of the projected image.1) Press as to select [SHARPNESS].2) Press qw or the button.f The [SHARPNESS] individual adjustment screen is displayed.3) Press qw to adjust the level.Operation Adjustment Range of adjustmentPress w. Contours become sharper. 0 - +15Press q. Contours become softer.[NOISE REDUCTION]You can reduce noises when the input image is degraded and noise is occurring in the image signal.1) Press as to select [NOISE REDUCTION].2) Press qw or the button.f The [NOISE REDUCTION] individual adjustment screen is displayed.3) Press qw to switch the item.f The items will switch each time you press the button.[OFF] No correction.[1] Slightly corrects the noise.[2] Moderately corrects the noise.[3] Strongly corrects the noise.Attentionf When this is set for an input signal with less noise, the image may look different from the original image. In such a case, set it to [OFF].
