Chapter 4 Settings — [NETWORK/USB] menuENGLISH - 145[SUBNET MASK] 255.255.255.0[DEFAULT GATEWAY] 192.168.11.1[DNS1]/[DNS2] (Blank)[PROJECTOR NAME]Name of the projector can be changed. Enter if a host name is required when using the DHCP server, etc.1) Press as to select [PROJECTOR NAME].2) Press the button.f The [PROJECTOR NAME CHANGE] screen is displayed.3) Press asqw to select the character, and press the button to enter the character.f Up to 16 characters can be entered.4) Once the entry of the projector name is completed, press asqw to select [OK], and press the button.f To cancel, select [CANCEL].Notef The factory default of the projector name is “Namexxxx”. xxxx is the last four digits of the network ID. The network ID is a fixed valueassigned to each product. The network ID can be confirmed in the standby screen projected when switched to Panasonic APPLICATIONinput.[NETWORK CONTROL]Set up the control method of the network.1) Press as to select [NETWORK CONTROL].2) Press the button.f The [NETWORK CONTROL] screen is displayed.3) Press as to select an item, and press qw to change the setting.[WEB CONTROL] Set to [ON] to control with the web browser.[PJLink CONTROL] Set to [ON] to control with the PJLink protocol.[PJLink NOTIFICATION]Set to [ON] to use the PJLink notification function.f The [PJLink NOTIFICATION] screen is displayed when set to [ON] and the button ispressed. Set the IP address of the computer to notify the status of the projector in [NOTIFIED IPADDRESS 1], [NOTIFIED IP ADDRESS 2].[COMMAND CONTROL] Set to [ON] to control with the control command format (x page 215) for the terminal.Refer to “Control commands via LAN” (x page 210).[COMMAND PORT] Set the port number used for command control.[Crestron Connected(TM)] Set to [ON] to control with Crestron Connected TM of Crestron Electronics, Inc.[AMX D.D.]Set to [ON] to control with the controller of AMX Corporation.Setting this function to [ON] enables detection through “AMX Device Discovery”. For details, visit thewebsite of AMX Corporation.URL http://www.amx.com/[EXTRON XTP]Set to [ON] when connecting the “XTP transmitter” of Extron Electronics to the terminal.The [EXTRON XTP] setting must be set to [OFF] when connecting the optional DIGITAL LINK outputsupported device (Model No.: ET-YFB100G, ET-YFB200G).For details of the “XTP transmitter”, visit the website of Extron Electronics.URL http://www.extron.com/4) Press as to select [STORE], and press the button.f The confirmation screen is displayed.5) Press qw to select [OK], and press the button.[MEMORY VIEWER]Set the operation of the Memory Viewer.1) Press as to select [MEMORY VIEWER].
