Chapter 3 Basic Operations — Switching on/off the projector58 - ENGLISHPower indicatorIndicate the status of the power. Check the status of the power indicator before operatingthe projector.Power indicator Indicator status Projector statusOff The main power is switched off.RedLitThe power is switched off. (standby mode)Projection will start when the power <v/b> button is pressed.f The setting of the projector is as follows.g The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [QUICK STARTUP]is set to [OFF]g The [PROJECTOR SETUP] menu → [AUDIO SETTING] → [IN STANDBY MODE] isset to [OFF]f The projector may not operate when the light source indicator or thetemperature indicator is blinking. (x page 196)BlinkingThe power is switched off. (standby mode)Projection will start when the power <v/b> button is pressed.f The projector is set to one of the following. Power consumption is high.g The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [QUICK STARTUP]is set to [ON]g The [PROJECTOR SETUP] menu → [AUDIO SETTING] → [IN STANDBY MODE] isset to [ON]f The indicator will change to a red light when the specified time has elapsed after theprojector enters the standby mode if the projector is set as following.The specified time is a time set in the [PROJECTOR SETUP] menu → [ECOMANAGEMENT] → [QUICK STARTUP] → [VALID PERIOD].g The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [QUICK STARTUP]is set to [ON]g The [PROJECTOR SETUP] menu → [AUDIO SETTING] → [IN STANDBY MODE] isset to [OFF]f The projector may not operate when the light source indicator or thetemperature indicator is blinking. (x page 196)Green Lit Projecting.Orange Lit The projector is preparing to switch off the projector.The power is switched off after a while. (Changes to the standby mode.)Notef While the power indicator lights in orange, the fan is running to cool the projector.f For approximately five seconds after the projector is turned off, the indicator does not light up even if the power is turned on. Turn on thepower again after the power indicator lights/blinks in red.f The projector consumes power even in standby mode (power indicator lights/blinks in red). Refer to “Powerconsumption” (x page 219) for the power consumption.f The power indicator will blink if the projector receives a remote control signal.f The power indicator will blink slowly in green while the shutter function is in use (shutter: closed).
