Panasonic PT-MZ670 Operating Instructions Manual

Also see for PT-MW530: Operating instructions Operating instructions Operating instructions

Contents

Panasonic PT-MZ670 Operating Instructions Manual Manual pdf 119 page image

Chapter 4 Settings — [PROJECTOR SETUP] menuENGLISH - 119[COMMAND] Detailed settings of[COMMAND] Description[POWER ON] ― Switches on the projector.[STANDBY] ― Enters standby.[QUICK STARTUP][ON] Enables the function of the [PROJECTOR SETUP] menu → [ECOMANAGEMENT] → [QUICK STARTUP].[OFF] Disables the function of the [PROJECTOR SETUP] menu → [ECOMANAGEMENT] → [QUICK STARTUP].[SHUTTER] [OPEN] Disables the shutter function (shutter: open).[CLOSE] Enables the shutter function (shutter: closed).[INPUT][RGB1] Switches the input to RGB1.[RGB2] Switches the input to RGB2.[VIDEO] Switches the input to VIDEO.[HDMI1] Switches the input to HDMI1.[HDMI2] Switches the input to HDMI2.[DIGITAL LINK] Switches the input to DIGITAL LINK.[MEMORY VIEWER] Switches the input to MEMORY VIEWER.[Panasonic APPLICATION] Switches the input to Panasonic APPLICATION.[MIRRORING] *1 Switches the input to MIRRORING.[INPUT1] - [INPUT10] *2 Switches the input to DIGITAL LINK, and switches the input of thePanasonic twisted-pair-cable transmitter to the specified input.[LIGHT POWER][NORMAL] Prioritizes luminance.[ECO] Controls the power to increase the life of the light source althoughthe luminance is lower than that of [NORMAL].[QUIET] Prioritizes the operation with less noise although the luminance islower than that of [NORMAL].[IN STANDBY MODE(AUDIO)] [OFF] Stops the audio output during standby.[ON] Outputs the audio during standby.[VOLUME] [0] - [63] Sets the volume.*1 [MIRRORING] is displayed when the optional Wireless Module (Model No.: ET-WM300) is attached.*2 When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the projector, its inputname is automatically reflected from [INPUT1] to [INPUT10]. When an item that does not reflect the input name is selected, it will be disabled.11) Press the button.f The command is fixed and n is displayed at the left of the selected command.f After the command is fixed, press the button to close the detailed setting screen.12) Press asqw to select [STORE], and press the button.Notef To delete a command that has been already set, press the button on the remote control while the screen in Step 5) isdisplayed, or select [DELETE] at the screen in Step 6) and press the button.f If multiple commands have been set for the same time, they are executed in chronological order starting from the smallest commandnumber.f The operating time will be the local time. (x page 117)f If an operation is executed with the remote control or control panel of the projector or with a control command before the command set in[SCHEDULE] is executed, the command set with the schedule function may not be executed.[RS-232C]Set the communication condition of the terminal. Refer to “ terminal” (x page 213).1) Press as to select [RS-232C].2) Press the button.f The [RS-232C] screen is displayed.3) Press as to select [INPUT SELECT].4) Press qw to switch the item.[PROJECTOR] Performs the RS-232C communication with the terminal of the projector.[DIGITAL LINK] Performs the RS-232C communication via the optional DIGITAL LINK output supported device (ModelNo.: ET-YFB100G, ET-YFB200G) and the terminal.