6. FACTORY RESETThis option resets ITP to factory default settings.7. REBOOTThis option reboots the ITP.NAVIGATING THE MENUSWhen programming within various menu options, information can be entered viathe dial pad keys using [0]-[9] and [✱✱] dial keys, as well as utilizing the navigationbutton assembly.The button used for editing and their features are summarized below.BUTTON FEATURESLeft and Right ......................To move a cursor (highlighted area) or to erase what isentered.Enter ........................................To save the current setting and end programming.End............................................To cancel the current programming and return to theMain Menu.Cancel......................................To move back to the previous screen or delete the lastdigit of the displayed option value.[✱✱] ............................................To enter [.] between IP address fields.[0]-[9] ......................................To enter numerical values.SETTING UP HOT DESKING (IDLE LOGIN)Hot Desking allows you to log in and out of your ITP-5112L IP keyset withoutrebooting.• From the System Easy Wizard choose option[5. Idle Mode].• Choose option[1. Idle Mode Enable/Disable].• Enter 1 to allow Hot Desking,Enter 0 to deny Hot Desking.• Press ENTER.• Press END twice.12SETTING THE NETWORK PARAMETERSUtilize the following programming steps to program the ITP-5112L IP keyset tooperate within the users network.System Easy WizardBy selecting this option, the System Easy Wizard can guide you through setting upyour network parameters. If you want to set up these parameters individually, fol-low the instructions below.Network Parameter SetupFrom the Configuration Main Menu, select [3.Network Setup] to set or modify the networkparameters. The LCD will display the NetworkSetup screen.• If [1. Manual IP] is selected, the user must enter the IP address, subnet mask,and gateway value for the customer network that the 5112L resides on.• If [2. DHCP] is selected, the IP address, subnet mask, and gateway value will beset to the default values automatically. (Choose this option only if a DHCPserver is available on the local network).• [3.PPPoE] (Point to Point Power over Ethernet):This option is selected in somecases when connecting directly to ISP (Internet Service Provider) equipmentwithout going through a local LAN. If so, you must enter the username/pass-word assigned to you by the ISP to authenticate your internet connection.Setting IP ManuallyIf [1. Manual IP] is selected the Network Setupsub menu will be displayed.The user directly enters the IP address, subnetmask, and gateway, address as follows:• If the [1. IP] menu is selected, the LCD will displaythe following message and the user can enterthe ITP’s address.Check if there is any currently saved IP address of the phone on the LCD. If the IPaddress has not been set, the LCD displays nothing. The user can enter the IPaddress using [0]-[9] dial buttons and [✱✱] button can save that IP address by press-ing the [Enter] button of navigation button assembly.Network Setup1.IP2.Subnet3.GatewayIP Addressxxx.xxx.xxx.xxx13Easy Setup1.Manual IP2.DHCP3.PPPoE4.Plug and Play (DHCP)5.Idle ModeIdle Mode1.Idle Mode Enable/DisableIdle Mode SetupIdle Mode:En(1)/Dis(0)Network Setup1.Manual IP2.DHCP3.PPPoE