154Set the Tear Bar DistanceTo set the tear bar distance, do the following steps:1. Make sure the printer is offline.2. Press ENTER key to enter Menu mode.3. Press the right arrow until the Config Menu icon is highlighted.4. Press ENTER to go into Config Menu.5. Press the down arrow until “ZTP SETTINGS” is highlighted.6. Press ENTER to go into the “ZTP SETTINGS” submenu.7. Press the down arrow until “ZTP TearDistance” is highlighted.8. Press the left arrow or right arrow to decrease or increase the tear bar distance in increments of1/144th of an inch.9. Press ENTER to select the desired value. An asterisk appears next the selected value and a scaleprints to indicate the tear bar distance in relation to the tear bar. For correct tear bar distance, thezero should align with the tear bar. See Figure 42.NOTE: The Tear Distance value must be changed to print the scale.Figure 42 Correct Tear Bar DistanceNOTE: When a new ZTP Tear Bar Dist value is selected, the printer will lose the current print positionuntil you reset the top of form to automatically save the new value.10. Reset the top of form using the procedure on page 155.Physical Tear BarPosition+500-50CorrectTear BarDistancePrint Station
