81Resp. PolarityThe Resp. Polarity parameter must be set to match the response polarity of your host computer.• Standard (default). Does not invert the response signal.• Inverted. Inverts the response signal sent to the host computer.Busy On Strobe• Enable (default). Asserts a busy signal after each character is received.• Disable. Asserts a busy signal only when the print buffers are full.Latch Data OnSpecifies whether the data is read on the leading or trailing edge of the data strobe signal. The default isleading.Prime Signal• Enable (default). The parallel port will perform a warm start (reboot) if the host asserts the primesignal.• Disable. The parallel port will not perform a warm start (reboot) if the host asserts the prime signal.TOF Action• Reset (default). A form feed is performed before a warm start when the prime signal is asserted fromthe host. This setting is used only if the prime signal parameter is enabled.• Do Nothing. Nothing occurs before a warm start when the prime signal is asserted from the host.Buffer Size in KConfigures the amount of memory allocated for the Centronics parallel port buffer. You can specifybetween 1 and 16 Kbytes, in 1-Kbyte increments.The default is 16K.Intellifilter SubmenuIntellifilter is a programmable feature, standard on TallyGenicom line printers. Without having to touch awell-working host system, Intellifilter permits users to free their systems from hard coded dependence ona specific printer that is no longer maintainable, or able to meet the demands of the application.Disable*EnableIntellifilter(from page 62) * = Factory DefaultFileManagementLANParallelSerialDisable*EnableDisable*EnableDownloadDelete
