49Quick SetupHost InterfaceThe Host Interface menu enables you to select and configure interfaces between the printer and yourhost computer. Options include:• Auto Switching (default). This menu selects which host I/O is currently active (see page 75). Otherselections include Centronics, Serial, IEEE 1284, USB, and Ethernet. Note that selections will onlyappear if installed.• Parallel Hotport. This submenu controls the parameters for hot porting with the Centronics or IEEE1284 interface.• Serial Hotport. This submenu controls the parameters for hot porting with the serial interface.• USB Hotport. This submenu controls the parameters for hot porting with the USB interface.• Ethernet Hotport. This submenu controls the parameters for hot porting with the Ethernet interface.BuffersAll ConfigsCurrent ConfigsResetQuick Setup(from page 48)Active HostAuto Switching*Centronics 2SerialIEEE 12842USBEthernet 1Parallel Hotport 2Port TypeTrickle TimeTimeoutReport StatusSerial HotportTrickle TimeTimeoutReport StatusUSB HotportTimeoutEthernet HotportTimeoutSwitch Out OnSer/Par Emul CPITally ANSI* 10*Genicom ANSI 12P5000 13.33P6000 15P600 16.67DEC LG01 17.14HP2564C 20IBM Proprinter 5Epson FX-1180 6MTPL 6.67Lan Emulation 1 7.5Tally ANSI* 8.33Genicom ANSI 8.57P5000 LPIP6000 1.5P600 2DEC LG01 3HP2564C 4IBM Proprinter 5Epson FX-1180 6*MTPL 8Length (lines) 966* 101-255 12Length (inches)11.0”*00.1 – 25.5Ribbon End PointDarker +6Darker +5Darker +4Darker +3Darker +2Darker +1Normal*Lighter -1Lighter -2Lighter -3Lighter -4Lighter -5Lighter -6Lighter -7Lighter -8Lighter -9Lighter -10* = Factory Default1 If Ethernet is installed.2 If Parallel is installed.ClearConfigurationRibbonEmulationHostInterfaceSave Config.Cfg 1*Cfg 2 – Cfg 8Power-Up ConfigCfg 1*Cfg 2- Cfg 8Factory
