80Buffer Size in KThis option configures the amount of memory allocated for the serial port buffer. You may specifybetween 1 and 16 Kbytes, in 1-Kbyte increments.The default is 16K.Unsolicit RptThis option enables or disables Printer Device Status Reports to be sent to the host when a reportablestatus or error condition has occurred.• No (default). Disables all unsolicited status reports from the printer.• Small. Enables brief unsolicited status reports and sends an extended status report to the host.• Big. Enables extended, unsolicited status reports and sends an extended status report to the host.Parallel I/O SubmenuData Bit 8• Enable (default). Allows access to the extended ASCII character set.• Disable. The printer interprets bit 8 of each incoming data character as a zero, regardless of itsactual setting.Data PolarityThe Data Polarity parameter must be set to match the data polarity of your host computer.• Standard (default). Does not expect the host computer to invert the data.• Inverted. Expects the data received on the data lines from the host computer to be inverted. Onesbecome zeros, and vice versa.Enable*DisableParallel I/O 1(from page 62) * = Factory Default1 If Parallel is installed.LatchData OnBusy OnStrobeResp.PolarityData PolarityData Bit 8 Prime SignalStandard*InvertedStandard*InvertedEnable*DisableLeading*TrailingEnable*DisableReset*Do Nothing16K*(1K-16K)Buffer Sizein KTOF Action
