65Codes SubmenuAuto LF (Line Feed)Auto LF causes the printer to perform a Line Feed each time it receives a Carriage Return Control Code.This parameter is available for host systems that cannot send a Line Feed Control Code.Some computers automatically generate a Line Feed of their own at the right margin. If your system doesthis and if Auto LF is enabled, it will result in a double-space between lines of print. Consult yourcomputer manual to determine whether this function should be turned off or on. Default is OFF.Auto CR (Carriage Return)Auto CR allows the printer to perform a Carriage Return (moves print location to the left margin) when itreceives either a Line Feed or Vertical Tab Control Code. The default value depends on the emulation(see Emulate under the Config Menu, Printer category, page 62).OFF*ONCODES(from page 62)* = Factory Default1 If P5000 emulation is selected.2 If Genicom ANSI emulation is selected.Print on CRWrapLine FeedLine WrapAuto CRAuto LF Form FeedAt TOFONOFF*ONOFF*ONOFF*OFF*Double StrikeBoldEnable*DisableEnable*DisableDisable*EnableDisable*EnableIgnoreDelete CharDelete BufferSapceFill*ON*OFFOFF*0-255OFF*0-255OFF*0-2551*1-2558*10.3Enable*DisableEnable*DisableTOFControl 2PTX ALS 1PTX SFCC 1Sub CharToSub CharFromDC3Operation 2Print80-9F HexCode 7FUpper OnlyAlt ESCESC Ignore CharDisable*EnableBarcodTop Pos 2SISOOverszBar 2OverszTop Pos 2Enable*DisableEnable*Disable
