TallyGenicom LMPPLS Administrator's Manual

Contents

TallyGenicom LMPPLS Administrator's Manual Manual pdf 89 page image

89• Novram Err Log. Prints detailed information about the most recent Novram related failure that hasoccurred. It is useful when the front panel reports “BAD NVM” or “ILL NVM” error types. Contact theCustomer Solutions Center and provide this information if such an error occurs.• All Characters. Prints all characters from the available character sets.Test WidthSet this parameter to run the self-tests at full width or 80 columns.Paper Out DotsCAUTION Only authorized service representatives should set this parameter.This parameter is used to adjust the paper out distance from the perforation; you can specify where thelast line on the page will print when there is a paper out condition. Setting this parameter correctlyprevents printing on the platen.Phase ValueDuring the Phasing Test, this value changes until printing is phased. The range is between 1-2000.System MemoryDisplays the amount of RAM installed (128 Megabytes).Print StatisticsYou can view various printer statistics and refer to them for preventive maintenance purposes. Printerstatistics accumulate continuously; they do not reset when you turn off the printer. All of the printerstatistics are set to zero at the factory after burn-in testing.• On. The cumulative time in hours the printer has been powered on. The range is 0 to 30,000 hours.• Print. The cumulative time in hours the printer has actually been printing. The range is 0 to 30,000hours.• Print Strokes. The cumulative number of back-and-forth shuttle strokes the printer has printed duringnormal printer operation. The range is 0 to 2,147,483,647 shuttle strokes.• Print Lines. The cumulative number of lines the printer has printed. The range is 0 to 2,147,483,647print lines.• 11 inch Pages. The cumulative number of pages the printer has printed. The range in print pages is0 to 2,147,483,647 total inches of paper movement divided by 11.• Poweron Pages. The number of 11 inch pages that have been printed since the current power on ofthe printer.Auto Dump• Disable (factory default).• Enable. When a printer receives a ‘E03x’ message type on the control panel, a dump file will beautomatically created and stored in flash as file “autodbg1.dbg” or “autodbg2.dbg” in the printer filesystem. This file can be uploaded to the host using the PrintNet Enterprise Suite application. Uponreceipt of this file, it should be sent to TallyGenicom Customer Support for review and evaluation.Fault Override SubmenuThis submenu deals with the configuration of fault information from the engine.