162If there is not enough space on the SD to save the entire flash image, you will be prompted with thefollowing message.This is a fatal error and requires user intervention. Cycle power on the printer, when prompted to save theQCMC select to skip. The printer will boot online and allow access to the Main File Mgmtmenus located under the Config Menu. Delete unnecessary SD files then try the QCMC Save operationagain.Copying the QCMC “Snapshot” Image to a SecondPrinterAlways power off the printer before removing or inserting the QCMC. Place the QCMC into the secondprinter’s memory slot. Upon power up, the printer software detects the presence of a QCMC and a checkof the QCMC will be performed to determine if there is already a saved flash image from this QCMC onthe printer. If no, the following message will display:NOTE: This message will appear every time at power-up until the QCMC settings are copied to theprinter.If the key is pressed, the printer will reboot into normal operation and not copy anyinformation to the printer. On subsequent power-ups the Copy message above will display again if theQCMC remains installed in the printer.NOTE: If the QCMC remains installed in the printer, the MAC address onboard will be used in place ofthe resident MAC address to the printer’s LAN/WAN interface card.When the key is pressed, the printer will not go online immediately, but will copy the contentsof the QCMC to the printer’s flash, creating a clone of the original printer. Before the copy process isallowed to continue, checks of the printer configuration will be made. If either of the checks fail, amessage will display on the front panel (in the hierarchy shown on page 162) and the printer will not copyany settings.Save CompletePrinter Will NowReboot...NOT ENOUGHSPACE ON SDDelete SD FileQCMC DETECTEDCopy to Printer?Yes...Press No...Press
