73PGL TerminatorDetermines whether or not a CR-LF terminator for PGL commands will cause a line feed to occur.• CR. Allows line feeds which follow the carriage return to be executed.Example: ~EXECUTE;TEST~NORMALThe above example would execute three line feeds following the job TEST.• CR-LF (default). Will not execute line feeds following a carriage return. In the above example, the LFswould not execute.BlkMaxH, BlkMaxV, BlkMinH, BlkMinVThese four parameters provide the ability to create block characters using FreeType fonts. However, theuser may find that very small FreeType characters are not legible, and very large FreeType charactersmay print too slowly. These four allow the user to select the minimum and maximum horizontal andvertical size of block characters that will be generated using the FreeType characters.Postnet DensityDetermines whether POSTNET bar codes are printed in Low Density (72 DPI) or High Density (144 DPI).Low Density is the default setting. POSTNET bar codes printed in High Density will print at half the speedof Low Density.Code V Grph DenThis parameter allows for graphic items in Code V to be printed in either single density (Normal) or doubledensity (High). The default is Normal.IMB DensityDetermines whether the horizontal Intelligent Mail barcodes (IMB) are printed in Low Density (120 DPI) orHigh Density (180 DPI). Low Density is the default setting. IMB barcodes printed in High Density will printat lower speeds.Configurations SubmenuYour printer can save up to eight personalized configurations, so you don't have to recreateconfigurations you use frequently. In addition, each configuration you save can be tagged with a label ofup to 15 characters. The Level 2 headings are as follows:Cfg 1*Cfg 2-Cfg 8CONFIGURATIONS(from page 62)* = Factory DefaultNameConfigsPower-UpConfig.DeleteConfig.Load Config.Save Config. Reset CfgNamesCfg 1*Cfg 2-Cfg 8FactoryAll*Cfg 1-Cfg 8Cfg 1*Cfg 2-Cfg 8Name Config 1Name Config 2…Name Config 8Cfg 1*Cfg 2-Cfg 8AllEnable*DisableAuto Save
