Tascam DP-24SD Owner's Manual

Also see for DP-24SD: Troubleshooting supplement

Contents

Tascam DP-24SD Owner's Manual Manual pdf 54 page image

54 TASCAM DP-24SD9 - Using Built-In EffectsCalling effects from the guitar effect library1. On the Guitar Effect screen, press the F2 (LIBRARY)button to display the library list.2. Use the JOG/DATA dial to select the effect setting that youwant to call, and then press the F4 (t) button.3. The setting is called and the display returns to the GuitarEffect screen.Press the F1 (g) button to return to the Guitar Effect screenwithout changing the parameter.NOTEThe preset data is stored in PRESET, and the user settingsare stored in USER.Saving guitar effects in the libraryYou can save an edited setting as a user setting in the library.1. When the Guitar Effect screen is displayed, press the F2(LIBRARY) button to display the PRESET/USER library list.Use the JOG/DATA dial to select the USER area, and thenpress the F3 (SAVE) button.NOTEThe library list contains a PRESET area and a USER area.PRESET area data cannot be overwritten.2. Enter a name, if necessary.Names of the PRESET library cannot be changed.Send effectsThe send effects can be used to send signals to Send Effect 1.You can select one among the 3 types of send effects (REVERB,DELAY, CHORUS) available. You cannot use multiple types ofeffects simultaneously.Using send effectsYou can send input channel or track signals to the send effects.Channel signal send levels and pre/post selection are performedon the Mixer screen. (See “Sending signals to internal/externaleffects” on page 38.)The return from this effect is sent to the stereo bus. In Bouncemode, however, it is sent to the bounce bus. (See “Bouncingtracks” on page 43.)Editing send effectsThe parameter editing is performed on the EFFECT screen.Press the EFFECT button to open the EFFECT screen, andwhile the Guitar Effect is displayed, press the F1 (SEND) buttonto switch to the Send Effect screen.Press the F3 (SELECT) button to select the effect type(REVERB, DELAY, CHORUS).Use the CURSOR (5/b/g/t) buttons to select theparameter that you want to change, and then use the JOG/DATA dial to select the value.Calling the send effect library1. On the Send Effect screen, press the F2 (LIBRARY) buttonto display the library list.2. Use the JOG/DATA dial to select the effect setting that youwant to call, and then press the F4 (t) button.3. The setting is called and the display returns to the SendEffect screen.Press the F1 (g) button to return to the Send Effect screenwithout changing the parameter.Saving send effects in the libraryYou can save an edited setting as a user setting in the library.1. When the Send Effect screen is displayed, press the F2(LIBRARY) button to display the PRESET/USER library list.Use the JOG/DATA dial to select the USER area, and thenpress the F3 (SAVE) button.NOTEThe library list contains a PRESET area and a USER area.PRESET area data cannot be overwritten.2. Enter a name if necessary.Names of the PRESET library cannot be changed.