4 Copying4-8 Xerox PE220Collation CopyingThis special copy feature is available only when you load documents in theADF.1. Load the documents to be copied in the ADF.2. Press Menu until “Copy Feature” appears on the top line of the display.3. Press the scroll button ( or ) until “Copy Collate” displays on the bottomline.4. Press Enter to make your selection.5. If necessary, customize the copy settings, including Lighten/Darken andoriginal type, by using the control panel buttons. See “Selecting CopyOptions” on page 4-5.6. Press Start to begin copying.Auto Fit CopyingThis special copy feature can be applied only when you place a document onthe document glass. If a document is detected in the ADF, Auto Fit copyingdoes not work.1. Place the document to be copied on the document glass, and close thecover.2. Press Menu until “Copy Feature” appears on the top line of the display.3. Press the scroll button ( or ) until “Auto Fit” appears on the bottom line.4. Press Enter to make your selection.5. If necessary, customize the copy settings, including Lighten/Darken andoriginal type, by using the control panel buttons. See “Selecting CopyOptions” on page 4-5.6. Press Start to begin copying.NOTE: You cannot adjust the copy size using the Reduce/Enlarge buttonwhile Auto Fit copying is enabled.ID Card CopyingYou can copy both sides of the ID Card to a single side of paper.When you copy using this feature, the machine prints one side of the card onthe upper half of the paper and the other side on the lower half withoutreducing the size of the original.If the original is larger than the printable area, some portions may not beprinted.This special copy feature can be applied only when you place a document onthe document glass. If a document is detected in the ADF, ID Card copyingfeature does not work.123123A
