4 CopyingXerox PE220 4-91. Place the ID Card to be copied on the document glass and close thecover.2. Press Menu until “Copy Feature” appears on the top line of the display.3. Press the scroll button ( or ) until “ID Card Copy” displays on thebottom line.4. Press Enter to confirm your selection.5. If necessary, customize the copy settings, including Lighten/Darken andoriginal type, by using the control panel buttons. See “Selecting CopyOptions” on page 4-5.6. Press Start to begin copying.Your machine begins scanning the front side.7. When “Set Backside” displays on the bottom line, open the documentcover and turn the card over. Close the cover.8. Press Start again.NOTE: If you press the Stop/Clear button or if no buttons are pressed forapproximately 30 seconds, the machine cancels the copy job and returns toStandby mode.2 Up or 4 Up CopyingThis copy feature is available only when you load documents in the ADF.1. Load the documents to be copied in the ADF.2. Press Menu until “Copy Feature” appears on the top line of the display.3. Press the scroll button ( or ) until “2 UP” or “4 UP” displays on thebottom line.4. Press Enter to make your selection.5. If necessary, customize the copy settings, including Lighten/Darken andoriginal type, by using the control panel buttons. See “Selecting CopyOptions” on page 4-5.6. Press Start to begin copying.NOTE: You cannot adjust the copy size using the Reduce/Enlarge buttonfor making a 2 or 4 Up copy.Poster CopyingThis special copy feature can be applied only when you place a document onthe document glass. If a document is detected in the ADF, the Poster copyingfeature does not work.1 23 41 22-up copying4-up copying
